Contents
First impressions
The Captain 240 comes with two 120 mm PWM fans, a 4-port fan hub that only has a 4-pin power connector, an illustrated user manual, and all necessary mounting brackets for both Intel and AMD systems. As the supported sockets are not listed on the product page, here is a short list:
Intel:
LGA2011-v3 | LGA2011 | LGA1366 | LGA115X
AMD:
FM2+ | FM2 | FM1 | AM3+ | AM3 | AM2+ | AM2
The Deepcool Captain 240 is well made. The pump including the cooling unit is made of plastic, but gives a solid impression. The cooling element is made of copper, on which I could not detect any uneven surfaces or even scratches. A layer of thermal paste is already applied. Unfortunately, no additional tube of thermal paste was included. The pump including the cooling element appears quite bulky overall. The pump is also illuminated during operation and pulses red.
The hose between the radiator and the pump is firmly connected and made of hard plastic. It is not too soft, nor too hard, so its ribbed design allows it to be bent easily within the case. The hose section between the pump and the cooling element, however, is transparent and made of PVC. Here, you can clearly see the reddish coolant.
The radiator is quite flat, measuring just 27mm. However, the very fine fins it features are a positive aspect.
The two 120mm fans also make a good impression. They are PWM fans with rubberized housings, which are intended to further reduce vibrations. The maximum speed is approximately 2200 RPM.
I was surprised by the small fan HUB included in the package. It allows you to connect up to four fans. Unfortunately, there is no fan controller. You either rely on the BIOS or use Speedfan.
Installation
Installing the Captain 240 AIO is simple. The included backplate has two orientations, either for an Intel or an AMD system. It is also labelled, so you really can't make any mistakes here. Small plastic inserts that prevent the screws from turning were also included and prove to be extremely useful. Once the backplate is connected to the mainboard, the pump and cooling element are simply screwed onto the CPU. Installation here differs barely from installing a conventional air cooler. The pump receives power via the CPU fan connector on the mainboard.
Cooling performance & volume
I connected the water cooling to a Core i7 920 (D0 stepping) which I overclocked to 4.2 GHz. The VCore is 1.26 V in this case.
At idle with approximately 1% CPU load and a fan speed of 1400 RPM, the average temperature is around 40-44°C. The fan noise remains within acceptable limits and is by no means unpleasant.
With Prime95 and the Small FFTs test enabled, the maximum temperature rises to an average of 64-67°C after approximately 20 minutes. The fans spin at full speed during this test, and the noise level becomes noticeably distracting and unpleasant over time. However, it should be noted that almost every fan becomes audible under full load.
The pump of the Captain 240 operates quietly. A faint hum can only be heard if you listen very closely.
Our verdict
The Deepcool Captain 240 AIO excels primarily in one area. It looks extremely good and stands out from other AIOs thanks to its black and red colour combination. The build quality is good, and installation is straightforward.
I would describe the cooling performance of the Captain 240 as average to good compared to other AIOs. At high fan speeds, it can certainly outperform many comparable AIOs and even air coolers. Unfortunately, full-load fan operation is not suitable as a permanent state, which is clearly noticeable in the noise levels. At idle, the cooling performance is decent, but there is hardly any difference compared to a good air cooler.
What impresses me about the Captain 240 AIO, however, is that the temperature is kept constant and temperature spikes hardly occur. The radiator, in particular, is really well designed with its very narrow fins and does a very solid job despite its low height of 27mm. This AIO is also recommended for overclockers, as the maximum temperature of the individual cores is kept in a comparatively low range even under full load.
For overclocking, the Deepcool Captain met my expectations. As a regular user, I would rather go for a good air cooler, as it clearly offers a better price-to-performance ratio. However, if you are looking for a stylish cooling solution, you should definitely check out the Deepcool Captain 240.
Specifications
General
- *Fan dimensions
- 120X120X25mm(2pcs)
- *Net weight
- 1183±10g
- *Fan speed
- 600±200~2200±10% RPM
- *Fan airflow
- 182.24CFM (MAX)
- *Fan air pressure
- 3.71mmH2O(MAX)
- *Fan life expectancy
- 100000 hours
- *Fan noise level
- 17.6~39.3dB(A)
- *Fan bearing (type)
- Liquid bearing
- *Fan connector
- 4-pin
- *Fan rated voltage
- 12VDC
- *Fan rated current
- 0.26±10%A(MAX)
- *Fan power consumption
- 3.12W
- *Radiator dimensions
- 274X120X27mm
- *Radiator material
- Aluminium
- *Pump lifespan
- 120000 hours
- *Pump connection
- 3-pin
- *Pump operating voltage
- 6~13.8 VDC
- *Pump rated voltage
- 12VDC
- *Pump speed
- 2,800±10% RPM
- *Pump current
- 0.25±10%A(MAX)
- *Pump power consumption
- 3.0W
What’s included
*2x 120mm PWM fans *4-port USB hub *User manual *Intel and AMD mounting brackets








Comments